# Chapt1 basic knowledge of mechanical drawing

Now there is another magnet at 30 angular distance on Rotating Disk on both side of the magnet M1. But think of friction between rotating disk and Shaft, it can be neglected by using magnetic joint between them.

Free energy from magnets respects the same rule. Such is the example of this magnetic motor. If all the objects are made precisely with measurements given and the rectangular cubic magnets are powerful enough to rotate more then 30 degrees in first repulsion then the system will work.

So the magnet over G1 rotate in the direction perpendicular to that of fixed-disk surface. My duty as a green optimistic is to collect everything I see someone has struggled explaining and demonstrating, put it in one place and let the people see and comment.

Now the angle and teeth ratio of G0 and G1 is such that when the magnet M1 moves 30 degree, the other magnet which came in the position where M1 was, it will be repelled by the magnet of Fixed-disk as the magnet on Fixed-disk has moved degrees on the plate above gear G1.

Now the magnet over the left disk will try to rotate the disk below in think clock-wise direction. When designing you may think of losses or may think that when rotating disk rotates 30 degrees and magnet M0 will be rotating clock-wise on the plate over G2 then it may start to repel M1 after it has rotated about 25 degrees, the solution is to use more powerful magnets.

Perendev was charged of scamming some people and even served for a while. One fixed plate over rotating disk with North side parallel to disk surface, and other on the rotating plate connected to small gear G1.

What do you think? On the left primary measurements of needed objects are given.

If you find any reason of not running this mechanism let me know. Now the large gear G0 is connected directly to Rotating disk with a rod. So after repulsion if Rotating-Disk rotates it will rotate the gear G0 which is connected to gear G1.

Visited 9, times, 1 visits today Like and share. I must not think of this!

The space between two disk is just more than the width of magnets M0 and M1 and space needed for connecting gear G0 to rotating disk with a rod.

Still, maybe someday someone will be able to produce free energy by using magnet motors. Here friction and other losses are neglected as magnets are much more powerful.

I need no proof! So if the first repulsion of Magnets M1 and M0 is powerful enough to make rotating-disk rotate degrees or more the disk would rotate till error occurs in position of disk, friction loss or magnetic energy loss.Many have tried building an energy-producing magnetic motor.

I am seeing a lot of in my daily quest through alternative energy news, but what I have learned is that energy is not free, perpetual motion machines do not exist, everything is taken from somewhere and put elsewhere.

Chapt1 basic knowledge of mechanical drawing
Rated 4/5 based on 22 review